CYBEX 500C Owner's Manual download pdf (Page 18)

Cybex 500C Cycle and 500R Recumbent Cycle Owner’s Manual

Page 2-8

Setting Options

The 500 series cycle offers an easy-to-access setup menu to let you match the cycle's

default settings and limits to your users' needs and the way you want to run your facility. You

can set the maximum workout length, the language and measurement units used on the

display, and more.

To set options:

1. Enter setup mode by holding down the Switch Display key while pedaling to activate the

console. You must keep pedaling while you change the settings.

2. For each of the following settings, use the up and down arrows to choose the value you

want, then press Enter to move on to the next option.

• Longest Workout Time ("Long Prog"): The longest time a user is allowed to set for his

or her workout. The original setting is 20 minutes. You can change this up to the

absolute maximum of 60 minutes.

• Default Workout Time ("Def Prog"): This is the default time shown when a user begins

a workout. The factory setting is 20 minutes; you can set this as high as the Maximum

Workout Time.

• Idle Time ("Until Idle"): How long the bike remembers workout information after a

work out, or if someone stops during a workout. You can set this to 30 seconds, one

minute, or two minutes. You can also choose to have no idle time; the bike will

remember the information until someone starts a new workout.

The idle time setting is used only if you have your 500 series cycle plugged in! If

you are using pedaling power to operate the console, 500C Cycle and 500R

Recumbent Cycle can remember workout information only for about 10 seconds after

someone stops pedaling.

• Always Prompt or Get On and Go: If you choose "Get On and Go," a user can get on

the 500 series cycle and start a manual workout without entering any workout

information. The default is "Full Set Up."

When a user chooses "Get On and Go" operation, the 500C Cycle and 500R

Recumbent Cycle uses the default workout length (the one set as "First Workout

Time").

• Key Beep: Should the console keys beep when pressed? Choose Yes or No

• USA Readout, Euro, or International ("Intl"): The USA readout uses miles for distance

and calories/hour for power; the Euro readout uses metric units for distance and

watts for power; the Intl readout uses metric units for distance and calories/hour for

power.

3. When you're done setting options, press the Clear key twice to save your settings and

leave setup mode.

If you decide not to change the settings, stop pedaling and let the console turn off with

out leaving setup mode. All settings keep their previous values.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

No comments

CYBEX 500C Owner's Manual Page 18