CYBEX AUTOVIEW COMMANDER - User's Guide download pdf (Page 18)

AutoView Commander Installer/User Guide

System Control &

Maintenance

Key Sequence Action

<CM>Kn<Enter> Sets the keyboard scan set where n is a scan set number 1-3.

<CM>MR<Enter> If you hot-plug your mouse cable, you may experience a loss of

mouse signal. Use this command to restore the signal if you are

using a PC with a standard PS/2 mouse driver.

<CM>MW<Enter> If you hot-plug your mouse cable, you may experience a loss of

mouse signal. Use this command to restore the signal if you are

using a PC with a Microsoft IntelliMouse driver.

<CM>AV<Enter> Displays the current firmware version of the processors inside

your AutoView unit. You must be either at a DOS prompt or in a

text editor/word processor to view this information.

<CM>H1<Enter> Changes the hot-key sequence to the default:

1. Press and hold down the ‘Num Lock’ key.

2. Press and release the minus (-) key on the numeric keypad.

3. Release the ‘Num Lock’ key.

<CM>H2<Enter> Changes the hot-key sequence to the 1st alternate:

1. Press and hold down the ‘Num Lock’ key.

2. Press and release the asterisk (*) key on the numeric keypad.

3. Release the ‘Num Lock’ key.

<CM>H3<Enter> Changes the hot-key sequence to the 2nd alternate:

1. Press and hold down the ‘Control’ key.

2. Press and release the tilde (~) key.

3. Release the ‘Control’ key.

<CM>ZM

<Enter> Use this command to resynchronize the mouse after a device or

computer hot-plug. Repeat, if necessary, until synchronization is

re-established.

Note: Using this command while the mouse is operating

correctly will cause the mouse to lose sync.

The following commands are used for system control and maintenance.

Enter the command sequences to perform the actions described in the

table below.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 46 47

No comments

CYBEX AUTOVIEW COMMANDER - User's Guide Page 18