CYBEX AUTOVIEW COMMANDER - User's Guide download pdf (Page 34)

AutoView Commander Installer/User Guide

B: Pairing

Pairing connects two AutoView units serially, allowing access to 16

computers with one keyboard, monitor and mouse without using a

computer port. It is used in place of cascading two units. To pair your

AutoView units, use the instructions below instead of those given in the

Installation chapter.

Initial Configurations

1. Select one of your two AutoView units to be used as the slave unit.

2. Connect your VGA monitor cable to the port labeled

on the back of

this unit. Next, connect your keyboard to the port labelled

on the

same unit.

3. Locate the power cord that came with your AutoView unit. Plug it into

the IEC power connector on the AutoView. Make sure that the AutoView

power switch is off, then plug the other end of the power cord into an

appropriate AC wall socket. This socket must be near the equipment

and easily accessible to allow for unplugging prior to any servicing of

the unit.

SETUP

USER

100-240V , .1A, 50/60 Hz

PATENT PENDING

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 46 47

No comments

CYBEX AUTOVIEW COMMANDER - User's Guide Page 34