CYBEX AUTOVIEW COMMANDER - User's Guide download pdf (Page 18)

AutoView 200 Installer/User Guide

Convention Key Sequence or Value

Enter Command Mode:

<CM> 1. Press and hold down the ‘Num Lock’ key.

2. Press and release the minus (-) key on the numeric keypad.

3. Release the ‘Num Lock’ key.

Note: For alternate hot-key sequences, see ‘System Control &

Maintenance’ later in this chapter.

<Enter> Press the ‘Enter’ or ‘Return’ key. The <Enter> command is used to

execute an instruction and exit from Command Mode.

Addr

The letters over the push-buttons on your AutoView 200 are your

PCs' addresses. Enter the letter, A-H, for the PC you're selecting. For

cascaded systems, enter the address of the base unit first.

Example

: You have an AutoView 200 unit cascaded from channel

B of your base unit. To access the PC at channel C of this second

(cascaded) unit, enter BC.

<ESC> Press the ‘Escape’ key. The <ESC> command is used to exit

Command Mode without executing an instruction.

The following notational conventions appear throughout this chapter to

illustrate commands for operating the AutoView 200. Whenever you see

one of the symbols listed on the left side of the table, substitute the

corresponding steps or values listed on the right side of the table.

Keyboard Control

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 46 47

No comments

CYBEX AUTOVIEW COMMANDER - User's Guide Page 18