CYBEX Juno-Fix User's Guide download pdf (Page 15)

PLACING THE CHILD SEAT IN THE CAR

• Place the child seat on the appropriate seat in the car.

• To install the seat in an upright position for the child it is essential

to take care that the backrest (a) of the child seat lies flush against

backrest of the car seat. To achieve this, push the seat toward the car

seat backrest.

• By using the ISOFIX anchorage points (i) in the car, you can adjust this

distance with the handle (v) on the underside of the child seat.

• If the headrests of the car seats get in the way, pull these completely

out, turn them round, or detach them completely (exception see section

„THE BEST POSITION IN THE CAR“). The backrest (a) adjusts itself in

one movement to almost every position of the car seat.

RELEASING THE ISOFIX CONNECTORS

Note! Retracting the connectors not only protects the car seat, but also protects the

ISOFIX CONNECT system from dirt and damage.

Note! Some car seat covers made from delicate materials (e.g. velour, leather etc.)

may be marked by the use of child seats. This can be avoided by placing a blanket or

a towel beneath the child seat.

• Release the ISOFIX connectors (w) on both sides, by pressing and

pulling back the red release buttons (y).

• Pull the seat out of the ISOFIX guides (u).

• Turn the ISOFIX connectors (w) 180°.

• Activate the handle (v) on the underside of the child seat and push the

connectors in until they reach the end position.

Carry out the installation steps in reverse order.

WARNING! The CYBEX JUNO- x backrest must lie ﬂ ush with the back of the car

seat. In order to guarantee maximum protection for the child, the seat must be

in a normal, upright position. (exception see section „SITTING AND RECLINING

POSITION“)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

No comments

CYBEX Juno-Fix User's Guide Page 15