CYBEX Juno-Fix User's Guide download pdf (Page 21)

• Put the child in the child seat.

• Put the previously adjusted safety cushion (p) in place (see section

„ADJUSTING THE SAFETY CUSHION“)

• Draw out the three-point automatic belt to its fullest extent. Take the lap belt (n)

and insert it into the belt routing marked in red (r) of the safety cushion (p).

• Push the belt tongue (m) into the belt buckle (l). This must lock into place with

an audible „CLICK“.

• Pre-tension the lap belt (n) by pulling on the shoulder belt (f).

• Now guide the shoulder belt (f) back through the belt routing (r) of the safety

cushion (p).

• Pull the shoulder belt (f) taut, taking care that both parts of the belt run over the

total width of the safety cushion (p), within the belt routing (r).

• the safety cushion (p) is correctly adjusted.

• the belt tongue (m) has locked into place in the belt buckle (l).

• the lap belt (n) and the shoulder belt (f) are running taut through the belt routing

of the safety cushion (p) and are not twisted.

• the seat cushion (d), when ISOFIX Connect is used, has locked into place on

both sides with the connectors (w) into the ISOFIX anchorage points (i) and

both green safety indications (x) can be seen clearly.

• the backrest (a) of the child seat lies completely flush with the backrest of the

car seat. (Exception see section, „SITTING AND RECLINING POSITION“).

SECURING THE CHILD

To guarantee the maximum safety for your child, please test the following before

departure:

IS YOUR CHILD PROPERLY SECURED?

WARNING! Do not twist the belt!

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 29 30

No comments

CYBEX Juno-Fix User's Guide Page 21