CYBEX 530S Owner's Manual download pdf (Page 37)

Cybex 530S Owner’s Manual

WARNING: Serious injury could occur if these

inspection and maintenance

actions are not observed.

Inspect the drive cables regularly for signs of

wear and replace them every six to eight months

with Cybex-supplied replacement cables. See

Figure 1 for location of drive cables.

Follow the procedure below to ensure that the

cables are in good condition. NOTE: If a cable

has cracks or appears worn, it must be replaced

immediately by a qualified service technician.

Tools Required

• None

WARNING: To prevent electrical shock, be

sure that the unit is unplugged

from the electrical outlet before

performing any cleaning or

maintenance procedures.

1. Read and understand this Drive Belt Maintenance section thoroughly before proceeding to

step 2.

2. Disconnect the external power source.

A. Locate the on/off (I/O) power switch on the front of the stepper. Toggle it to the on (I) position.

B. Unplug the stepper from the power outlet.

3. Inspect the drive cables.

A. While kneeling next to the stepper push one pedal all the way to the floor.

B. Inspect the drive cable for signs of wear, cracking or discoloring.

C. Carefully return the pedal to it’s starting position.

D. Repeat procedure for other drive cable.

Drive

Cables

Figure 1

Preventive

Maintenance

Page 4-3

Drive Cable Maintenance

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44

No comments

CYBEX 530S Owner's Manual Page 37