CYBEX AUTOVIEW COMMANDER - User's Guide download pdf (Page 20)

14 AutoView 200/400 Installer/User Guide

To connect an extended access Sun user station (AutoView 400 only):

NOTE: This requires a VAK-1 adaptor kit available from Avocent.

Figure 2.4: Extended Access Sun User Station Installation

1. Plug a standard CAT 5 cable (up to 500 feet) into the RJ-45 modular jack on

the rear of the AutoView. Avocent C5T or P5T cable is strongly recommended

to achieve best performance and maximum distance. If you use a different

CAT 5 cable, ensure it is terminated to the EIA (TIA) 568 B standard.

2. Route the CAT 5 cable to the location where you intend to place the

secondary monitor, keyboard and mouse.

3. If your monitor uses a 13W3 plug, attach the 15HDD male adaptor into the

monitor port of your LongView receiver and the monitor cable into your VAK-1

adaptor. Otherwise plug the monitor directly into the LongView receiver.

4. Plug the ends of the 6-pin miniDIN VAK-1 keyboard/mouse adaptor into

the corresponding ports on your LongView receiver, then plug the Sun

keyboard/mouse cable into the VAK-1 adaptor.

REMOTE I/O

RECEIVER

–––+

24VDC

.5A

LongView

Sun User Station

VAK-1 Video Adaptor

13W3 Video Connector

Keyboard/Mouse

Connector

VAK-1 Keyboard/

Mouse Adaptor

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 59 60

No comments

CYBEX AUTOVIEW COMMANDER - User's Guide Page 20