CYBEX AUTOVIEW COMMANDER - User's Guide download pdf (Page 33)

Chapter 3: Basic Operations 27

3. Highlight Edit Channel and press Enter.

4. Highlight ID Setup and press Enter. The ID window will appear. Follow

the procedures outlined in the table below to conﬁ gure your ID window.

ID Window Settings

To … Procedure

Move the ID window Use the Arrow keys or mouse to move the ID window's

position on the monitor. (Hold down the Shift key to move

faster.) If the window ﬂ ickers but does not move, continue

pressing the Arrow keys until it moves back into range.

Change window background color Press the Page Up key to cycle through the available

window background colors.

Change text color Press the Page Down key to cycle through the

available text colors.

Change window length Press the Plus (+) and Minus (-) keys to change the

length of the ID window.

Change window size Press Space to toggle between large and small.

Access ID window Help Press F1.

5. Press Enter to accept the new settings.

-or-

Press Escape to exit the setup screen without saving the changes.

Setting the ID window dwell time

This menu selection lets you set the time that the ID window remains on

screen after a channel switch. Each channel can be configured independently.

The default time is set for five seconds.

To set the ID window dwell time:

1. Press the Control key twice to access the Administrator Channel List.

2. Highlight the channel you wish to change in the Administrator Channel List.

3. Press Control twice again. The Administrator Commands menu appears.

4. Highlight Edit Channel and press Enter. The Edit Channel menu appears.

5. Highlight ID Dwell Time. Enter a number between Ø-255 seconds. Typing

Ø disables the ID window. Typing 255 allows the ID window to stay on the

screen the entire time the channel is active. Press Enter.

6. Highlight Save Changes and press Enter.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 59 60

No comments

CYBEX AUTOVIEW COMMANDER - User's Guide Page 33