CYBEX AUTOVIEW COMMANDER - User's Guide download pdf (Page 40)

34 AutoView 200/400 Installer/User Guide

commands that can be activated via the keyboard without having to access the

OSD. The following procedures and tables describe your options.

NOTE: Hotkey switching is only available in the default non-secure state. For more information

on security, see Setting User Station Security in this chapter.

Using the Command Mode

The first set of keystrokes places your system in Command Mode. A gray

window with a line for commands will appear. As long as you are operating in

Command Mode, whatever you type will be interpreted as channel switch

commands until the Enter or the Escape key is pressed to terminate Command

Mode. None of the keystrokes entered will be forwarded to the attached

computer until you exit Command Mode.

To activate the Command Line:

1. Press and hold down the Num Lock key.

2. Press and release the Minus (-) key on the numeric keypad.

3. Release the Num Lock key. The Command Line menu appears.

Figure 3.9: Command Line Menu

NOTE: In the following tables, the Command Mode procedure is referred to by the <CM>

symbol. When you see this symbol, perform the above key sequence.

To select servers without displaying the OSD:

1. Press the <CM> sequence to access the Command Line.

2. Type the channel address of the computer you wish to access. For

cascaded systems, enter the address of the base unit, then the address of

the cascaded unit. Example: You have an AutoView unit cascaded from

channel B of your base unit. To access the computer at channel C of this

second (cascaded) unit, type BC.

3. Press Enter to accept the new channel.

The following table shows an example of a hotkey switching session to

demonstrate how you might switch to various channels in a system.

Command Line

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 59 60

No comments

CYBEX AUTOVIEW COMMANDER - User's Guide Page 40