CYBEX 500C Owner's Manual download pdf (Page 15)

Attaching the Seat Back Assembly

As shown in Figure 1 on the previous page, attach the seat back assembly (2) to the seat

shuttle with four 5/16 x 1-1/2 button-head cap screws (9) and lock washers (12), using a 3/16"

hex wrench. If you have difficulty aligning the screws, loosen the four button-head cap screws

on the back of the seat. Attach seat supports to the seat shuttle and fully tighten, then

tighten screws on the seat back.

Attaching the Display Upright

All of the cable connections are shown in detail A of Figure 1. Connect the two ends of the

ribbon cable (5 and 6) which emerge from the cycle base and the display upright (3). Connect

the ends of the Polar cable (4 and 11) or the CardioTouch cable (7 and 10), if applicable. To

help support the display upright, move the seat forward and rest the handlebar of the upright

on the seat.

Loosen the top cover screw (see detail A). Feed excess cable into the upright. Lift the display

upright and slide it down over the neck, taking care not to pinch the ribbon cable. Fasten the

display upright using three 5/16-18 x 3/8” button-head cap screws (8) and lock washers (12).

Tighten the top cover screw at the front of the cycle.

Attaching the Display Console

As shown in Figure 2, remove the display console (3) from the configuration kit. Attach the rib-

bon cable (7) from the display upright to the back of the display board. The connector is

keyed so you cannot insert it backwards. Attach the green ground cable (8) to the single flat

connector next to the ribbon cable connector. Make sure the cables are firmly connected

before continuing.

Cybex 700C Cycle and 700R Recumbent Owner’s Manual

Page 2-3

Figure 2

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

No comments

CYBEX 500C Owner's Manual Page 15