CYBEX LT-16602-4 Service Manual download pdf (Page 87)

Cybex Sport Treadmill Owner’s & Service Manual

5. Connect the cables.

A. Connect these cables into the display board: the display cable (2 connectors), the two

upper switch membranes, the lower switch membrane, the contact heart rate cable

and the upper to lower board jumper. See Figure 19.

6. Check the connections.

A. Check to see that all of the cables are connected firmly in their proper place.

7. Secure the console back.

A. While being sure not to pinch any cables, use a Phillips head screwdriver to secure the

three screws that hold the bottom back cover to the console front.

8. Calibrate speed.

A. Follow the Speed Calibration procedure located in this chapter.

Contact Heart Rate Board

NOTE: This procedure will cover the contact heart rate board and the CSAFE board with a

jumper.

Tools Required

• Phillips head screwdriver

• ESD (Electro Static Discharge) grounding strap

1. Disconnect the external power source.

A. Turn the main power switch on the left side to the off (O) position.

B. Unplug the treadmill from the power outlet.

NOTE: Wear an ESD strap for the rest of this procedure.

2. Remove the top console back.

NOTE: If you have a cable plugged into the RJ-45 port disconnect it.

A. Using a Phillips head screwdriver, remove the five screws that hold the top console

back to the console front.

B. Gently pull off the top console back.

3. Disconnect the cables from the display board.

A. Disconnect these cables from the display board: the display cable (2 connectors); the

two upper switch membranes; the lower switch membrane; the contact heart rate

cable and the upper to lower board jumper. See Figure 25.

Service

Page 7-31

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 97 98

No comments

CYBEX LT-16602-4 Service Manual Page 87