CYBEX 610A Service Manual download pdf (Page 24)

Cybex Arc Trainer 610A Service Manual

Service

Page 4-5

Speed Sensor Adjustment

Tools Required

• Phillips head screwdriver

! WARNING: Disconnect the power cord before beginning this procedure. Keep wet items away

from inside parts of the unit. Electrical shock could occur even if the unit is

unplugged.

1. Disconnect the external power source.

A. Turn the main power switch above the power

inlet to the off (O) position.

B. Unplug the power cord from the power outlet.

2. Remove the access cover.

A. Using a Phillips head screwdriver, remove the

four screws securing the access cover. See

Figure 2.

B. Remove the access cover.

3. Visually inspect the target disk on the lower

pulley.

A. Turn the lower pulley slowly and look for dirt,

scratches or other damage on the target disk.

See Figure 3. NOTE: If the target disk or

speed sensor is dusty use a soft dry cloth to

wipe off the dust. A dirty, scratched or

damaged disk may cause Error 3 to occur.

4. Measure the speed sensor gap.

A. Measure the gap between the speed sensor

and the lower pulley. It should measure 3/16”

(.48 cm) and should be parallel to the lower

pulley. See Figure 3.

Figure 2

Screws (4)

Access

Cover

Figure 3

Gap

Speed

Sensor

Screw

Target Disk

on Lower

Pulley

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 71 72

Comments to this Manuals

No comments

CYBEX 610A Service Manual Page 24

Comments to this Manuals

Related products and manuals for Fitness, gymnastics & weight training CYBEX 610A