CYBEX 610A Service Manual download pdf (Page 55)

Upper Display Cable

Tools Required

• 7/32” Allen wrench

• Phillips head screwdriver

• ESD (Electro Static Discharge) grounding strap

1. Disconnect the external power source.

A. Turn the main power switch above the power inlet to the off (O) position.

B. Unplug the power cord from the power outlet.

NOTE: Wear an ESD strap for the rest of this procedure.

2. Remove the console front.

A. Using a Phillips head screwdriver, remove the screw securing the access cover to the console

back. See Figure 27.

B. Using a Phillips head screwdriver, remove the four screws securing the console front to the

console back. See Figure 27.

C. Gently pull the console front forward and disconnect these cables from the display board: the

display cable; the contact heart rate cable; ground wire and the polar heartrate cable.

See Figure 28.

3. Remove the console mount.

A. Using a 7/32” Allen wrench, remove the four screws and four lock washers securing the

console mount in place. See Figure 29.

B. Remove the console mount by lifting upward.

4. Remove the upper display cable.

A. Disconnect the upper display cable from the lower display cable. See Figure 29.

5. Attach the new upper display cable.

A. Locate the end of the upper display cable with the single connector. See Figure 29.

B. Connect the upper display cable to the lower display cable. NOTE: If you are changing the

lower display cable disregard this step.

Service

Page 4-36

Cybex Arc Trainer 610A Service Manual

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 71 72

No comments

CYBEX 610A Service Manual Page 55