CYBEX 610A Service Manual download pdf (Page 39)

Cybex Arc Trainer 610A Service Manual

Service

Page 4-20

Power Switch

Tools Required

• Phillips head screwdriver

1. Disconnect the external power source.

A. Turn the main power switch above the power inlet to the off (O) position.

B. Unplug the power cord from the power outlet and from the power inlet.

2. Remove the access cover.

A. Using a Phillips head screwdriver, remove the four

screws securing the access cover. See Figure 2.

B. Remove the access cover.

3. Remove the power switch assembly.

A. Using a Phillips head screwdriver, remove the two

screws on each side of the power switch. See

Figure 18.

B. Reach inside the unit and pull the power switch

assembly up and out of the slot.

C. Make note of which fast-ons are connected to the

connectors.

D. Disconnect the three wires from the Filtered Power

Input Module (middle one).

E. Connect the three wires (removed from step 5D) to the new Filtered Power Input Module See

Figure 4.

F. Remove the three wires from power outlet module and remove this module from the old switch

plate.

G. Place the existing power outlet module into the new switch plate.

H. Connect the wires as shown in Figure 4.

I. With two pieces of tape, mark the top two wires to the on/off switch. NOTE: The purpose for

marking the top two wires is so that you do not accidentally bypass the on/off switch when

reconnecting the wires.

J. Remove the four wires from the on/off switch and remove the switch from the old switch plate.

K. Place the existing on/off switch into the new switch plate (positioned exactly as removed from

the old switch plate).

L. Connect the four wires as shown in Figure 4. Make sure the taped wires are connected to the

same connectors from step 5I. Remove the tape from the two wires.

Figure 18

Screw (2)

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 71 72

No comments

CYBEX 610A Service Manual Page 39