CYBEX 610A Service Manual download pdf (Page 52)

TOOLS REQUIRED

• Phillips screwdriver

• Needle nosed pliers

• Two (2) Fuses, part number EF-12417.

1. Disconnect the external power source.

A. Turn the main power switch above the power inlet to the off (0) position.

B. Unplug the power cord from the power outlet.

! WARNING: Disconnect the power cord before continuing this procedure. Keep wet items away

from inside parts of the unit. Electrical shock could occur even if the unit is

unplugged.

2. Remove the access cover.

A. Using a Phillips screwdriver, remove the four screws and four washers securing the access

cover. See Figure 2.

B. Remove the access cover.

! WARNING: Flywheel may be hot. Wait until it cools before servicing.

! WARNING: Do not touch components on the lower board. A charge can remain after

unplugging the power cord and turning off the unit.

3. Replace the fuses.

A. Locate the lower board.

B. Pull out on the lower board shield (it will snap

out). See Figure 26.

C. Locate the fuses in the upper left hand corner

of the control board. See Figure 26.

D. Replace the old fuses with the new fuses.

E. Place the lower shield (removed in step 5B)

into position and secure the finned fasteners

(the shield with snap in).

F. Attach the access cover removed in steps 2A

and 2B. NOTE: Be careful not to pinch any

cables.

Cybex Arc Trainer 610A Service Manual

Service

Page 4-33

Figure 26

Fuses

Lower Board Shield

Finned

Fasteners

(4)

Lower Control Board Fuses

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 71 72

No comments

CYBEX 610A Service Manual Page 52