CYBEX 610A Service Manual download pdf (Page 41)

Cybex Arc Trainer 610A Service Manual

Service

Page 4-22

Upper Pillow Blocks

Tools Required

• Phillips head screwdriver

• 3/16” Allen wrench

• 1/8” Allen wrench

• 7/16” Socket wrench

• 9/16” Socket wrench

• 9/16” Open end wrench

• 3/8” Nutdriver or socket wrench

! WARNING: Disconnect the power cord before beginning this procedure. Keep wet items away

from inside parts of the unit. Electrical shock could occur even if the unit is

unplugged.

1. Elevate the unit and disconnect the power source.

A. Plug the power cord into the power outlet.

B. Enter Test Mode.

C. Elevate the unit to a minimum of level 7 incline.

D. While the unit is elevated, turn the main power switch to the off (O) position and unplug the

power cord from the power outlet.

2. Remove the access cover.

A. Using a Phillips head screwdriver, remove the four screws securing the access cover. See

Figure 2.

B. Remove the access cover.

! WARNING: Flywheel may be hot. Wait until it cools before servicing.

3. Detach the connecting rods.

A. Using a 3/16” Allen wrench, remove the screw securing each connecting rod to each crank.

See Figure 4.

B. Place a cloth on the frame where each connecting rod will rest.

C. Rest each rod on a cloth to prevent scratches. See Figure 4.

4. Remove the side covers.

A. Using a Phillips head screwdriver, remove the six screws and six washers securing each side

cover in place. See Figure 5.

B. Remove both side covers. NOTE: The gasket will come off with one of the side covers. See

Figure 5.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 71 72

No comments

CYBEX 610A Service Manual Page 41