Cybex 770T Treadmill User Manual download pdf (Page 28)

Cybex Owner’s Manual

Power cord management

Power cord retaining brackets are located under the front end of the unit. This allows any extra length

of the power cord to be stored under the front end of the unit.

Tools Required

Wire tie (2)

Elevate treadmill

1. Connect the main power cord into the power outlet.

2. Press Quick Start and raise the elevation to maximum incline.

3. Toggle the on/off (I/O) power switch to the off (O) position.The on/off (I/O) power switch is

located under the front end of the unit, or on the front right side panel.

Description

1 Front right side panel

location

2 Under the front end

location

4. Unplug the main power cord from the power outlet.

WARNING: Shock and electrocution hazard.

• Route power cord so it does not become damaged.

• Do not allow cord to be pinched or interfere with movement of treadmill.

5. Wrap the power cord around the outer power cord retaining brackets to desired length.

Description

1 Power cord

2 Power cord retaining

bracket, Inner

3 Power cord retaining

brackets, Outer

The power cord can be routed with full or half wraps around power cord retaining brackets. The power

cord can then exit to the left or right of the treadmill.

Description

1 Power cord

2 Half wrap

3 Full wrap

4 Exit left or right

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 97 98

No comments

Cybex 770T Treadmill User Manual Page 28